Flush-mounted 500W electronic roller module for wired system

The MVR500E flush-mounted module is a wired actuator for the management of motorized roller shutters, blinds, shutters and awnings, with a 3 or 4-wire motor up to 500W (powered at 230V). Can be operated with both single and double non-interlocked buttons, using the R12M accessory. The device provides the daily scheduling function, which allows the automatic daily opening and closing of the rolling shutter through two separate timers. The MVR500E modules can be centralized, via a single pilot wire, by sending the up or down command to all roller shutter motors (requires R12M accessory), even in the presence of dedicated local commands for each device (DV600 accessory required) and in case long distances of the pilot wire (requires CVI34 accessory). The integrated torque control avoids damaging the shutter or the motor in the event of an obstacle, and allows you to activate the reverse movement of the shutter in the event of motor overload. The simplicity of installation and customization of the behavior make it extremely economical in terms of installation time: the removable terminal block simplifies the connections during installation and the pilot wire can be added at the time of power supply wiring. Possibility to define an intermediate position (which can be recalled with 2 presses on the button) and to configure electronic limit switches. It also allows control via a low voltage button (12 or 48 V), both in direct and alternating, with the addition of the ADBT accessory. Accessories: CVI34 (code 5454806): Converter for permanent contact for shutter modules. D600V (code 5454072): Diode for centralization via pilot wire. R12M (code 5454073): Interface for double button (not interlocked). ADBT (code 5454076): 12-48V AC or DC low voltage adapter.